GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Bursting Strength of Textiles-Constant-Rate-of-Traverse. Standard Test Method for Bursting Strength of Textiles-Constant-Rate-of- Traverse (CRT) Ball Burst Test. Theory: ASTM D is used to determine the. ASTM D Standard Test Method for Bursting Strength of Textiles—Constant- Rate-of-Traverse (CRT) Ball Burst Test.

Author: Kabar Douhn
Country: Dominica
Language: English (Spanish)
Genre: Love
Published (Last): 11 January 2010
Pages: 23
PDF File Size: 16.11 Mb
ePub File Size: 13.30 Mb
ISBN: 786-2-58516-973-8
Downloads: 29398
Price: Free* [*Free Regsitration Required]
Uploader: Zujas

Combining values from the two systems may result in nonconformance within the specification.

If a bias is found, either the cause must be determined and corrected or future test results must be adjusted in consideration of known bias. Referenced Documents purchase separately The v3787 listed below are referenced within the subject standard but are not provided as part of the standard.

The values stated in each system are not exact equivalents; therefore, each system may be used independently of the other. Within the test, the inch-pound units are shown in parentheses.


ASTM D Textile Ball Burst Testing – ADMET

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The kind of force transfer and strength that occur when knitted goods are worn is prevented by clamping them as directed in this test method.

For awtm measurement of bursting strength with a hydraulic testing machine, refer to Test Method D33787 In cases of disagreement arising from differences astmm values reported by the purchaser and the seller when using Test Method D for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined with comparison based on testing specimens randomly drawn from one sample of material of the type being evaluated.

Historical Version s – view previous versions of standard.

ASTM D – Ball Burst Puncture Fixture

Other materials with established test values may be used for this purpose. The test samples used should be as homogeneous as possible, drawn from the material from which the disparate test results were obtained, and randomly assigned in equal numbers to the laboratories for testing.


Test Method D is considered satisfactory for acceptance testing of commercial shipments of textiles fabrics for bursting strength since the method has been used extensively in the trade for acceptance testing. Link to Active This link will always route to the current Active version of the standard. The test results from the two laboratories should be compared using a statistical test for unpaired data at a probability level chosen prior to the testing series.

This standard does not purport to address all of the safety concerns, if any, associated with its use.